Experimenting with woven wire loom and latex rubber tube.
Clever shop tool (welder's ruler) here: https://tinyurl.com/ldfjy9y
Long term projects: http://www.Patreon.com/AvE
Clever shop tool (welder's ruler) here: https://tinyurl.com/ldfjy9y
Long term projects: http://www.Patreon.com/AvE
Holy moly, was this the video that started it all? I've seen other channels use this concept.
Note from Texas: you castrate bulls not cows…….
I think you should put a rod between the disk centres, allow them to swivel around that when pulled by the muscles. In this video, at least, the muscles are working, its just they have nothing to work against. Like a big muscleman with no skeleton – it's just a wibbly blob 🙂
Somebody needs to make a 3 arm circle cutter.
"Engage your safety squints!"
if you wiggle as you cut, as with your hole saws there, you can reduce stalling and jamming. the mechanisms are: slightly wider kerf gives clearance so the tool shank can't rub, and: tool pressure is focused into sectors. tool power is focused on that sector, so the motor has time to rewind to optimal rpm.
works for rotary and linear cutters
"Acme" Snatch and grab kit for apprehending road runners.
Did this vijayo just get republished? I had caught up on all the AvE, and this one from two years ago came to my feed today.
Is this fuck machine finished yet?
This man is my spirit animal
You don’t need no windex, just Hak a lugie on her