I sand on the inside of parts on the lathe by hand once in a while. That being said, never with a key way already cut into it. No thank you. That paper would catch the slot so fast, probably just spin your finger right around before your wrist/arm can even react.
you should check out "simple dyno" software, its free from their Google site, might save some dickering around. it uses magnetic pick up through a headphone jack and does all the calculations for you
How do I unlock this video?
I paid for this bullshit wtf AVE
Bullshit o meter as in bullshit Ill make that meter
2019 here – I am not mad that it's a pay-to-watch vid, I am disappointed that it isn't available!
Doesn't work anymore. How can I view?
Wtf is it?.??
Wish I could see
I sand on the inside of parts on the lathe by hand once in a while. That being said, never with a key way already cut into it. No thank you. That paper would catch the slot so fast, probably just spin your finger right around before your wrist/arm can even react.
you should check out "simple dyno" software, its free from their Google site, might save some dickering around. it uses magnetic pick up through a headphone jack and does all the calculations for you
"If you know C programming, please look away"… 🙂 🙂 🙂 🙂
ha ha I knew I had this video. Yes you need to finish this.
What happened to this one? Did the tool giants pay you to stop? 🙂
How do I rent this? I want to watch and support.
space shots how i miss you